Compulsory Valve Operation Check Mode - Subaru FORESTER 2001 Service Manual

COMPULSORY VALVE OPERATION CHECK MODE

Engine (Diagnostics)
14. Compulsory Valve
Operation Check Mode
A: OPERATION
1) Prepare Subaru Select Monitor kit. <Ref. to
EN(DOHC TURBO)-8, PREPARATION TOOL,
General Description.>
2) Connect diagnosis cable to Subaru Select
Monitor.
3) Insert cartridge into Subaru Select Monitor.
<Ref. to EN(DOHC TURBO)-8, PREPARATION
TOOL, General Description.>
4) Connect test mode connector (A) at the lower
portion of instrument panel (on the driver's side), to
the side of the center console box.
S088528
S088528A16
S2M0285
S2M0286A
S2M2244A
EN(DOHC TURBO)-48
5) Connect Subaru Select Monitor to data link
connector.
(1) Connect Subaru Select Monitor to data link
connector (A) located in the lower portion of the
instrument panel (on the driver's side).
(2) Connect diagnosis cable to data link con-
nector.
CAUTION:
Do not connect scan tools except for Subaru
Select Monitor and OBD-II general scan tool.
6) Turn ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
7) On the Main Menu
the {2. Each System Check} and press the [YES]
key.
8) On the System Selection Menu
screen, select the {Engine Control System} and
press the [YES] key.
9) Press the [YES] key after displayed the infor-
mation of engine type.
10) On the Engine Diagnosis
select the {System Operation Check Mode} and
press the [YES] key.
11) On the System Operation Check Mode
display screen, select the {Actuator ON/OFF
Operation} and press the [YES] key.
12) Select the desired compulsory actuator on the
Actuator ON/OFF Operation
and press the [YES] key.
13) Pressing the [NO] key completes the compul-
sory operation check mode. The display will then
return to the Actuator ON/OFF Operation
screen.
S2M2157B
S2M0288A
display screen, select
display
display screen,
display screen