Subaru Legacy 2002 Service Manual page 1057

Mechanical
(3) Brake booster vacuum hose
15) Connect the following connectors.
(1) Engine ground terminals
Tightening torque:
14 N·m (1.4 kgf-m, 10.1 ft-lb)
(2) Engine harness connectors
(3) Alternator connector and terminal (A)
(4) A/C compressor connectors (B)
ENGINE ASSEMBLY
16) Connect the following cables.
(1) Accelerator cable
B2M3419
CAUTION:
After connecting each cable, adjust them.
17) Install A/C pressure hoses.
<Ref. to AC-42, INSTALLATION, Flexible Hose.>
18) Install
INSTALLATION, V-belt.>
19) Install radiator to vehicle. <Ref. to CO(H6)-24,
INSTALLATION, Radiator.>
20) Install air intake duct, cleaner case and air
intake chamber.
<Ref. to IN(H6)-2, General Description.>
21) Install under cover.
22) Install battery in the vehicle, and connect
cables.
B2M4015
23) Fill coolant.
<Ref. to CO(H6)-18, FILLING OF ENGINE
COOLANT, REPLACEMENT, Engine Coolant.>
24) Check ATF level and correct if necessary.
<Ref. to AT-9, Automatic Transmission Fluid.>
25) Charge A/C system with refrigerant.
<Ref. to AC-23, OPERATION, Refrigerant Charg-
ing Procedure.>
26) Remove front hood stay, and close front hood.
27) Take off the vehicle from lift arms.
C: INSPECTION
1) Make sure pipes and hoses are installed cor-
B2M4016
rectly.
2) Make sure the engine coolant and ATF are at
specified levels.
B2M4017A
ME(H6)-36
V-belt. <Ref. to
S143079A10
B2M4018
ME(H6)-29,