Subaru Legacy 2002 Service Manual page 987

Fuel Injection (Fuel Systems)
B: INSTALLATION
1) Hold fuel filler flap open.
2) Set fuel saucer (A) with rubber packing (C) and
insert fuel filler pipe into hole from the inner side of
apron.
3) Align holes in fuel filler pipe neck and set cup
(B), and tighten screws.
NOTE:
If edges of rubber packing are folded toward the
inside, straighten it with a screwdriver.
4) Insert fuel filler hose (A) approximately 35 to 40
mm (1.38 to 1.57 in) over the lower end of fuel filler
pipe and tighten clamp.
CAUTION:
Do not allow clips to touch air vent hose (B)
and rear suspension crossmember.
FUEL FILLER PIPE
S145022A11
B2M1196A
B2M1196A
B2M4173A
FU(H6)-62
5) Insert air vent hose approximately 25 to 30 mm
(0.98 to 1.18 in) into the lower end of air vent pipe
and hold clip.
L = 27.5±2.5 mm (1.083±0.098 in)
(1) Hose
(2) Clip
(3) Pipe
6) Tighten bolt which holds fuel filler pipe bracket
on body.
Tightening torque:
7.4 N·m (0.75 kgf-m, 5.4 ft-lb)
B2M1195A
B2M3199