Compulsory Valve Operation Check Mode - Subaru IMPREZA 2002 Service Manual

I
COMPULSORY VALVE OPERATION CHECK MODE
ENGINE (DIAGNOSTICS)
14.Compulsory Valve Operation
Check Mode
A: OPERATION
1) Prepare the Subaru Select Monitor kit. <Ref. to
EN(S0HC)-8, PREPARATION TOOL, General De-
scription .>
2) Connect the diagnosis cable to Subaru Select
Monitor.
3) Insert the cartridge into Subaru Select Monitor.
<Ref. to EN(S0HC)-8, PREPARATION TOOL,
General Description.>
4) Connect the test mode connector (A) at the low-
er portion of instrument panel (on the driver's side),
to the side of the center console box.
5) Connect the Subaru Select Monitor to data link
connector.
(1) Connect Subaru Select Monitor to data link
connector located in the lower portion of the in-
strument panel (on the driver's side).
~ ~~ ~ ~
(2) Connect the diagnosis cable to data
connector.
CAUTION:
link
Do not connect scan tools except for Subaru
Select Monitor and OBD-II general scan tool.
6) Turn the ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
' '
'S2M0288A
7) On the ((Main Menu)) display screen, select the
(2. Each System Check} and press the [YES] key.
8) On the ((System Selection Menu)) display
screen, select the {Engine Control System} and
press the [YES] key.
9) Press the [YES] key after displayed the informa-
tion of engine type.
10) On the <<Engine Diagnosis), display screen, se-
lect the {System Operation Check Mode} and press
the [YES] key.
11) On the ((System Operation Check Mode)) dis-
play screen, select the {Actuator ON/OFF Opera-
tion} and press the [YES] key.
12) Select the desired compulsory actuator on the
((Actuator ON/OFF Operation)) display screen and
press the [YES] key.
13) Pressing the [NO] key completes the compul-
sory operation check mode. The display will then
return to the (<Actuator ON/OFF Operation,)
screen.
EN(S0HC)-44