Subaru Legacy 2002 Service Manual page 859

DIAGNOSTICS FOR ENGINE STARTING FAILURE
Engine (Diagnostics)
No.
10 CHECK INHIBITOR SWITCH CIRCUIT.
1) Turn ignition switch to OFF.
2) Place the selector lever in the "P" or "N"
position.
3) Separate transmission harness connector.
4) Measure resistance between transmission
harness connector receptacle's terminals.
Connector & terminal
(T3) No. 11 — No. 12:
11 CHECK TRANSMISSION HARNESS.
1) Disconnect connector from inhibitor switch.
2) Measure resistance of harness between
transmission harness and inhibitor switch con-
nector.
Connector & terminal
(T3) No. 11 — (T7) No. 7:
(T3) No. 12 — (T7) No. 12:
12 CHECK POOR CONTACT.
Check poor contact in inhibitor switch connec-
tor.
Step
Is the resistance less than
1 Ω?
Is the resistance less than
1 Ω?
Is there poor contact in
inhibitor switch connector?
EN(w/oOBD)-48
Check Yes
Repair open cir-
cuit in harness
between starter
motor and ignition
switch connector.
Go to step 12.
Repair poor con-
tact in inhibitor
switch connector.
No
Go to step 11.
Repair open cir-
cuit in harness
between transmis-
sion harness and
inhibitor switch
connector.
Replace inhibitor
switch.