Subaru Legacy 2002 Service Manual page 1054

23) Support transmission with a garage jack.
CAUTION:
Before moving engine away from transmission,
check to be sure no work has been overlooked.
Doing this is very important in order to facili-
tate re-installation and because transmission
lowers under its own weight.
(A) Transmission
(B) Garage jack
24) Separation of engine and transmission.
(1) Remove starter.
REMOVAL, Starter.>
(2) Remove bolts which hold upper side of
transmission to engine.
25) Install ST to torque converter clutch case.
ST 498277200 STOPPER SET
26) Remove engine from vehicle.
(1) Slightly raise engine.
(2) Raise transmission with garage jack.
(3) Move engine horizontally until main shaft is
withdrawn from clutch cover.
ENGINE ASSEMBLY
G2M0298A
<Ref. to SC(H6)-6,
B3M2045
H2M1961A
ME(H6)-33
(4) Slowly move engine away from engine
compartment.
CAUTION:
Be careful not to damage adjacent parts or
body panels with crank pulley, oil level gauge,
etc.
27) Remove front cushion rubbers.
B: INSTALLATION
1) Install front cushion rubbers.
Tightening torque:
34 N·m (3.5 kgf-m, 25.3 ft-lb)
2) Position engine in engine compartment and
align it with transmission.
CAUTION:
Be careful not to damage adjacent parts or
body panels with crank pulley, oil level gauge,
etc.
3) Tighten bolts which hold upper side of transmis-
sion to engine.
Mechanical
B2M4024
S143079A11
B2M4024