Applying A Route-Policy - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing

10.3.5 Applying a Route-Policy

A route-policy takes effect only when it is applied to a routing protocol.
Context
A route-policy can be applied to direct, static, RIP/RIPng, IS-IS, OSPF/OSPFv3, BGP/BGP4+,
multicast, and BGP/MPLS IP VPN routes. In addition, a route-policy can be applied to an FRR
scenario. Perform one of the following configurations as needed:
l
l
l
l
l
l
l
l
l
l
l
l
l
Procedure
l
Issue 02 (2014-09-30)
Apply a route-policy to direct routes.
Apply a route-policy to static routes.
Apply a route-policy to RIP routes.
Apply a route-policy to RIPng routes.
Apply a route-policy to IPv4 IS-IS routes.
Apply a route-policy to IPv6 IS-IS routes.
Apply a route-policy to OSPF routes.
Apply a route-policy to OSPFv3 routes.
Apply a route-policy to BGP routes.
Apply a route-policy to BGP4+ routes.
Apply a route-policy to multicast routes.
Apply a route-policy to BGP/MPLS IP VPN routes.
Apply a route-policy to an FRR scenario.
Apply a route-policy to direct routes.
1. Run:
system-view
The system view is displayed.
2. To apply a route-policy to specific direct routes, see
Table 10-2 Applying a route-policy to direct routes
Objectives
To configure a
device to advertise
ARP Vlink direct
routes that match a
route-policy on the
public network
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Command
arp vlink-direct-route
advertise [ route-policy route-
policy-name ]
10 Routing Policy Configuration
Table 10-2.
Reference
1.15 Configuring the
Advertisement of IPv4
ARP Vlink Direct
Routes on the Public
Network
1206