Operating in the "SYSTEM" area
2.4 Configuring the drive system
2.4
Configuring the drive system
Pressing this softkey opens the drive system configuration window where you can configure
the connected drives and motors.
Before starting the drive and motor configuration, you must ensure the Drive Bus addresses
are properly set (p0918) via the drive BOPs according to the instructions in the window
above.
Operating sequence
20
1.
Press this softkey on the main screen of drive system configuration, and
the control system starts to identify the drives and motors connected.
After the identification finishes, a drive list with motor information displays
on the screen, for example:
Note: For a motor with an absolute encoder, the motor ID can be
identified automatically. For a motor with an incremental encoder,
however, you must configure it manually.
2.
Select the motor to be configured using the cursor keys.
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual