Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 97
Hide thumbs
Also See for SINUMERIK 808D ADVANCED:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages)
Table of Contents
Advertisement
Remedy:
NC-Start
Program
Clear alarm with NC START or RESET key and continue the program.
Continuation:
10225
[Channel %1: ] command denied
Parameters:
%1 = Channel number
Definitions:
The channel has received a command that cannot be executed.
Reaction:
Alarm display.
Remedy:
Press RESET.
Program
Clear alarm with the Delete key or NC START.
Continuation:
10226
[Channel %1: ] Reset/program end canceled
Parameters:
%1 = Channel number
Definitions:
An error occurred during reset or program end, so that the channel cannot be switched to a ready state.
This can occur, for example, if the interpreter reports an error during the processing of the init. blocks created during
reset and program end.
As a rule, further alarms indicate the exact problem.
Reaction:
NC Start disable in this channel.
Channel not ready.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy:
Rectify the problem indicated by the other alarms, and press RESET again.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
10299
[Channel %1: ] Auto-Repos function is not enabled
Parameters:
%1 = Channel number
Definitions:
The Auto-Repos function (operating mode) was selected in the channel but is not implemented.
Reaction:
Alarm display.
Remedy:
This message is purely informational.
Program
Clear alarm with the Delete key or NC START.
Continuation:
10600
[Channel %1: ] Block %2 auxiliary function during thread cutting active
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
An auxiliary function output is programmed in a thread cutting block.
Reaction:
Alarm display.
Remedy:
Consequential errors can occur if the machining path of the thread block is too short and further blocks (thread blocks)
follow in which no machining stop may occur.
Possible remedial measures:
- Program a longer path and/or a lower traversing rate.
- Output auxiliary function in another block (program section).
Program
Clear alarm with the Delete key or NC START.
Continuation:
10601
[Channel %1: ] Block %2 zero velocity at block end point during thread cutting
Parameters:
%1 = Channel number
%2 = Block number, label
Diagnostics Manual
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
SINUMERIK 808D ADVANCED alarms
3.2 NCK alarms
97
Hide quick links:
Advertisement
Table of Contents
