Setting Start-Up Function - Siemens SINUMERIK 808D ADVANCED Diagnostic Manual

Operating in the "SYSTEM" area

2.2 Setting start-up function

An extended horizontal softkey bar can be accessed via this key on the PPU. Two extended
horizontal softkeys are provided:
2.2 Setting start-up function
Functionality
This softkey allows you to choose the NC, PLC, and drive start-up modes. You can set up the
start-up modes by pressing the respective softkeys.
Selecting an NC restart mode
Proceed through the following steps to select an NC restart mode:
Note
You must stop the machine before selecting the NC start-up mode.
10
Views the service information
Defines the maintenance planner
1. Select the desired operating area.
+
2. Press this softkey.
3. Press this softkey to open the window for selecting the NC start-up
mode.
4. Select a desired mode with the cursor keys. Three NC start-up
modes are available:
5. Press this softkey to confirm your selection. The system then restarts
in the mode selected.
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual