Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 369

61195 [Channel %1: ] Block %2: Aligning a turning tool is only possible with active turning
tool
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Aligning turning tools is only possible with one active turning tool.
Remedy: Change a turning tool, before you call alignment.
61196 [Channel %1: ] Block %2: No swiveling in JOG --> Multi-axis transformations and
TCARR activated at the same time
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Multi-axis transformations (TRAORI) and Toolcarrier (TCARR) activated at the same time.
Remedy: Deselection of multi-axis transformation with TRAFOOF
or deselection of Toolcarrier (TCARR) with CYCLE800()
61197 [Channel %1: ] Block %2: Swiveling - plane not allowed -> Error code %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: Error code:
61198 [Channel %1: ] Block %2: Swiveling with kinematic chain -> Error code: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: --
61199 [Channel %1: ] Block %2: Swiveling - tool not allowed -> Error code: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Error is also output if no swivel data record is active and only tool approach is programmed.
Remedy: A CYCLE800 must be called with a valid swivel data record before orientation.
Error code:
A: Orientation of tool and change of swivel data record not allowed
61200 [Channel %1: ] Block %2: Too many elements in machining block
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The machining block contains too many elements.
Remedy: Check the machining block, delete some elements if required.
61201 [Channel %1: ] Block %2: Wrong sequence in machining block
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The sequence of elements in the machining block is invalid.
Remedy: Sort the sequence in the machining block.
61202 [Channel %1: ] Block %2: No technology cycle
Parameters: %1 = Channel number
%2 = Block number, label
Diagnostics Manual
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
369