Cycle Alarms - Siemens SINUMERIK 808D ADVANCED Diagnostic Manual

SINUMERIK 808D ADVANCED alarms

3.5 Cycle alarms

400024 Dynamically managed memory used up, area %1
Definitions: Memory overflow in area corresponding to memory area identification
%1= 1xx: dynamic RAM, xx refers to internal RAM class
%1= 2: MMF (user project)
%1= 3: buffered RAM
%1= 4: UP-RAM
Reaction: Alarm display.
Remedy: With %1 = 1xx: Internal error due to too many external communications requirements
With %1 > 1: User project too large or too many operations
Program Clear alarm with the Delete key or NC START.
Continuation:
400025 PLC Ctrl Energy: Error in DB 9906
Definitions: PLC Ctrl Energy: DB 9906 has been deleted.
Reaction: PLC Stop
Remedy: DB 9906 of the programming tool library must be incorporated into the project.
Program Switch control OFF - ON.
Continuation:
400026 Alarm PLC cycle time, cycle time %1
Definitions: PLC cycle time has exceeded the alarm threshold
%1= xxxx: duration of the previous PLC cycle in µs
Reaction: Alarm display.
Remedy: User project is almost too large, too many operations or too many loops
Program Clear alarm with the Delete key or NC START.
Continuation:
400027 Error PLC cycle time, cycle time %1
Definitions: PLC cycle time has exceeded the maximum value
%1= xxxx: duration of the previous PLC cycle in µs
Reaction: PLC Stop
Remedy: User project too large, too many operations or too many loops
Program Switch control OFF - ON.
Continuation:
3.5 Cycle alarms
61000 %[[Channel %1: ] Block %2: %]No tool offset active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: D-correction must be programmed before the cycle call.
61001 [Channel %1: ] Block %2: Thread pitch incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: Check parameter for the thread size or setting for the pitch (contradict each other).
346
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual