Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 207

23
24
25
26
27
33
34
35
36
37
41
42
45
46
47
48
49
50
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Modify part program, retrofit option.
In this context, please compare the available option data and/or (if available) the license image of your controller.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14782 [Channel %1: ] Block %2 non-active function used (identification %3)
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Fine ID
Definitions: A non-active function is used in the block
Brief description of the identification
1
2
3
4
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: - Modify part program.
- Activate function.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14783 [Channel %1: ] Block %2 coordinate system-specific working area limitation is not
active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An attempt is made in the block to activate a group of the coordinate system-specific working area limitation.
However, this group is not set up (see MD28600 $MC_MM_NUM_WORKAREA_CS_GROUPS).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
The NC program is stopped. The G code of the group WALCS01 - WALCS10 can be changed.
Remedy: - Modify part programm.
- Activate more coordinate system-specific working area limitations.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
Diagnostics Manual
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Masl option
ExtLang or ExtLanguage option not activated
TechCycle option
Liftfast option
ProgAccel option
AllAsupSynact option
CmdAxSpind option
Mea2 option
ProgAnaOut option
OptAaTOff option
MachineMaintenance option
PathFeedSAInput option
ElecTransfer option
Cut3D option
CDA option
Reserved: generic coupling option
Measuring cycles option
ForceControl option
Transformation
H numbers of the tool
3D protection areas
Tool manager, multitools
SINUMERIK 808D ADVANCED alarms
3.2 NCK alarms
207