Configuring The Ethernet Connection - Siemens SINUMERIK 808D ADVANCED Diagnostic Manual

Operating in the "SYSTEM" area

2.11 Configuring the Ethernet connection

2.11 Configuring the Ethernet connection
Communication tool - Access MyMachine P2P (AMM)
With the tool Access MyMachine P2P (AMM) installed on your PC/PG, you can enable the
Ethernet connection between a SINUMERIK 808D ADVANCED control system and a PC/PG.
This tool is available in the SINUMERIK 808D ADVANCED Toolbox and is supported by
Windows XP/Vista/Win 7.
For more information about the AMM tool, refer to SINUMERIK 808D ADVANCED
Commissioning Manual.
Ethernet connections
The following Ethernet connections are possible between the control system and the AMM
tool on the PC/PG:
•
Direct connection: direct connection between the control system and PC/PG
•
Network connection: integrating the control system into an existing Ethernet network
Establishing a direct connection
Proceed as follows to establish a direct connection between the control system and a PC/PG:
46
1. Connect the control system with the PC/PG using an Ethernet cable.
2. Select the desired operating area on the PPU.
+
3. Press this key to view the extended softkeys.
4. Set up a direct connection on the control system through the
following softkey operations:
The following dialog pops up on the screen:
5. Start the Access MyMachine P2P (PC) on your PC/PG. A password
setting dialog appears when the tool is started for the first time.
6. Enter a desired password in the input fields and then click this button
to save.
This password ensures that all the connection data for AMM is
encrypted. The password can be subsequently changed at any time
from the menu bar.
→ →
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual