Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 51

Configuring the firewall
Use this softkey to enable or disable communication ports. To ensure maximum possible
safety, all ports not needed should be closed.
The Ethernet connection requires the ports 80 and 1597 for communication.
To change the port status, select the relevant port using the cursor and press the
to open or close the port.
Open ports are shown in the check box with a check mark.
Diagnostics Manual
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
9. Press this softkey to establish the server connection and assign the
local shared directory to the network drive.
You can disconnect a selected network drive using the following
softkey:
10 After you connect a network drive successfully, you may open it
. directly on the PPU using the following softkey either in the system
data management operating area or in the program management
operating area:
Operating in the "SYSTEM" area
2.11 Configuring the Ethernet connection
key
51