Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 121

Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
10784 [Channel %1: ] Block %2 illegal tool for tool radius compensation with constraint
surface
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: When activating the tool radius compensation with constraint surface, an illegal tool type is active.
Only cutting tools of the tool types 1 to 399 are admitted with the following exceptions:
- 111 ball end milling cutter
- 155 torus milling cutter
- 156 torus milling cutter
- 157 torus milling cutter
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Use another tool.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
10790 [Channel %1: ] Block %2 plane change during linear programming with angles
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The active plane was changed between the first and second subblock when programming two straight lines with angle
parameters.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
10791 [Channel %1: ] Block %2 invalid angle during linear programming
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No intermediate point was found when programming a contour consisting of two straight lines and an angle
specification.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
Diagnostics Manual
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
SINUMERIK 808D ADVANCED alarms
3.2 NCK alarms
121