Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 176

SINUMERIK 808D ADVANCED alarms
3.2 NCK alarms
Definitions: With involute interpolation, the end point of the involute must be outside the basic circle. The programmed center point
/ radius or end point must be adapted accordingly.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14037 [Channel %1: ] Block %2 involute: radius invalid
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: With involute interpolation, the programmed radius of the basic circle must be greater than zero.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14038 [Channel %1: ] Block %2 involute not definable: end point error
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed end point does not lie on the involute defined by the start point, radius and center point of the basic
circle. The deviation of the effective end radius from the programmed value is greater than the permissible value
specified in MD21015 $MC_INVOLUTE_RADIUS_DELTA.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14039 [Channel %1: ] Block %2 involute: end point programmed several times
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: With involute interpolation, either the end point with the geometry axis identifiers or the angle of rotation with AR=value
can be programmed. Simultaneous programming of end point and angle of rotation in one block is not allowed, since
the end point can thus not be defined exactly.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14040 [Channel %1: ] Block %2 error in end point of circle
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In circular interpolation, either the circle radii for the initial point and the end point are further apart, or the circle center
points are further apart, than specified in the machine data.
1. In circle radius programming the starting and end points are identical, thus the circle position is not determined by
starting and end points.
2. Radii: The NCK calculates from the present start point and the other programmed circle parameters the radii for the
start and the end point.
176
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual