Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 192

SINUMERIK 808D ADVANCED alarms
3.2 NCK alarms
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14320 [Channel %3: ] Axis %4: handwheel %1 used twice (%2)
Parameters: %1 = Handwheel number
%2 = Use
%3 = Channel
%4 = Axis
Definitions: Informational alarm indicating that the mentioned handwheel is used twice:
The second parameter provides the explanation:
1: Block with axial handwheel override for this axis cannot be executed as the handwheel
for this axis performs a DRF movement
2: Block with velocity override of the path cannot be executed as the handwheel performs
a DRF movement for this axis of the path
3: Block with contour handwheel cannot be executed as the handwheel performs a DRF movement
for this axis of the path
4: PLC axis with axial handwheel override cannot be started immediately as the handwheel performs
a DRF movement for this axis
5: The axis is a reciprocating axis with axial handwheel override; the reciprocating movement cannot be
started immediately as the handwheel performs a DRF movement for this axis
6: The DRF movement for this axis cannot be executed as an axial handwheel override is active for
this axis with the handwheel
7: The DRF movement for this axis cannot be executed as a velocity override of the path with
the handwheel is active and the axis belongs to the path
8: The DRF movement for this axis cannot be executed as the contour handwheel is active with
this handwheel and the axis belongs to the path
9: The DRF movement for this axis cannot be executed as the axis is a PLC axis with handwheel
override that is active with this handwheel
10: The DRF movement for this axis cannot be executed as the axis is active as reciprocating axis
with handwheel override with this handwheel
Reaction: Alarm display.
Remedy: Use the handwheel for one purpose at a time only.
Program Alarm display showing cause of alarm disappears. No further operator action necessary.
Continuation:
14400 [Channel %1: ] Block %2 tool radius compensation active at transformation switchover
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A change of transformation is not allowed when tool radius compensation is active.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Perform tool radius compensation in the NC part program with G40 (in a block with G00 or G01) before performing a
transformation change.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14401 [Channel %1: ] Block %2 transformation not available
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The required transformation is not available.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
192
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual