Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 373

61227 [Channel %1: ] Block %2: Target position cannot be reached: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The target position of the approach motion is outside the software limit switch. This situation may arise from swiveling
or coordinate rotations.
Remedy: If possible, lower retraction plane. Select alternative solution for swiveling (direction +/-) or clamp on workpiece
differently.
61228 [Channel %1: ] Block %2: Retraction plane for swiveling with swivel head not reached
due to software limit switches
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Retraction plane not reached!
Remedy: Correct retraction plane
61229 [Channel %1: ] Block %2: The external retraction plane must be greater than the
internal retraction plane
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The external retraction plane must be greater than the internal retraction plane.
Remedy: Correct the retraction planes.
61230 [Channel %1: ] Block %2: Tool probe diameter too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The tool probe has not been calibrated correctly.
Remedy: 840D sl - up to SW 1.x:
Check the following variables in data block GUD7: E_MESS_MT_DR[n] or E_MESS_MT_DL[n] for probe n+1
840D sl/828D - as from SW 2.5:
Check the following machine or setting data: 51780 $MNS_J_MEA_T_PROBE_DIAM_RAD[n]
61231 [Channel %1: ] Block %2: ShopMill program %4 not executable, as not tested by
ShopMill
Parameters: %1 = Channel number
%2 = Block number, label
%4 = Program name
Definitions: Before a ShopMill program can be executed, it has to be tested by ShopMill.
Remedy: The program first has to be simulated in ShopMill or loaded into the operating mode "Machine auto" by ShopMill.
61232 [Channel %1: ] Block %2: Impossible to load magazine tool
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Only manual tools may be loaded into a swivel head in which only manual tools can be loaded.
Remedy: Load a manual tool into the swivel head or set the parameter "Tool change" on the setup screen form "Rotary axes"
to "Automatic".
61233 [Channel %1: ] Block %2: Thread angle wrongly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The thread angles were specified too large or too small.
Remedy: Check thread geometry.
Diagnostics Manual
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
373