Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 344

SINUMERIK 808D ADVANCED alarms
3.4 PLC alarms
400008 Programming tool - version is not compatible %1 %2
Parameters: %1 = Programming tool version
Definitions: This version is not compatible with the product level of the controller.
Reaction: PLC Stop
Remedy: Translate the user program using a suitable programming tool version and load in the control.
Program Switch control OFF - ON.
Continuation:
400009 Computing time overrun at PLC level: %2 network %1
Parameters: %1 = Network number
%2 = Block type
Definitions: Check user program of the corresponding displayed network.
Reaction: PLC Stop
Remedy: Change user program
Program Switch control OFF - ON.
Continuation:
400010 Arithmetic error in user program: Type %2 network %1
Parameters: %1 = Network number, block ID
%2 = Error type
Definitions: Check user program in the stated network.
%2 = 1:Division by zero in fixed point arithmetic
%2 = 2:Floating-point arithmetic
Reaction: PLC Stop
Remedy: Change user program.
Program Switch control OFF - ON.
Continuation:
400011 Maximum number of subroutine levels exceeded: %2 network %1
Parameters: %1 = Network number
%2 = Block ID
Definitions: Check user program in the stated network.
Reaction: PLC Stop
Remedy: Change user program.
Program Switch control OFF - ON.
Continuation:
400012 Error affecting indirect addressing: %2, network %1
Parameters: %1 = Network number
%2 = Block ID
Definitions: Check user program in the stated network.
Reaction: PLC Stop
Remedy: Change user program.
Program Switch control OFF - ON.
Continuation:
400013 PLC user program is incorrect
Definitions: The PLC user program in the control is incorrect or is not available.
Reaction: PLC Stop
Remedy: Reload PLC user program.
344
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual