Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 363

Remedy: Error causes:
1. Error code = A -> no tool or no cutting edge (D1..) active
2. Error code = B -> swivel "no" and swivel "direct", swivel plane "additive" not permitted
3. Error code = C -> input value for rotary axis 1 not in the grid of the Hirth tooth system
4. Error code = D -> input value for rotary axis 2 not in the grid of the Hirth tooth system
5. Error code = E -> swivel "direct" programmed in automatic, but swivel commissioning not set up ($TC_CARR37
UNITS digit < =2)
6. Error code = F -> tool alignment with "swivel axes direct" programmed, but not setup in the kinematic transformation
($NT_IDENT[n,0] ONES digit = 0)
61154 %[[Channel %1: ] Block %2: %]Final depth wrongly programmed
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy: Input of end depth possible only absolutely or incrementally
61155 [Channel %1: ] Block %2: Unit for plane infeed wrongly programmed
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy: Unit for plane infeed possible only in mm or % of tool diameter
61156 [Channel %1: ] Block %2: Depth calculation wrongly programmed
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy: Depth calculation possible only with or without SDIS
61157 %[[Channel %1: ] Block %2: %]Reference point wrongly programmed
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy: Check reference point in screen form, input only -X, centred or +X
61158 %[[Channel %1: ] Block %2: %]Machining plane wrongly programmed
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy: Check machining plane (G17, G18 or G19) in connection with the parameter _DMODE
61159 [Channel %1: ] Block %2: Machining plane on cycle call differs from the one in the
position pattern
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy: Adjust the machining plane on cycle call to the machining plane in the position pattern.
61160 [Channel %1: ] Block %2: Residual material remains stationary, reduce plane infeed
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Diagnostics Manual
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
363