Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 418

SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
61802 [Channel %1: ] Block %2: Wrong axis type
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed axis is assigned to a spindle
Remedy: --
61803 [Channel %1: ] Block %2: Programmed axis not available
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed axis is not in the system.
Remedy: Check parameter _AXN.
Check MD20050-20080.
61804 [Channel %1: ] Block %2: Progr. position exceeds reference point
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed intermediate position or actual position is behind the reference point.
Remedy: --
61805 [Channel %1: ] Block %2: Value programmed absolute and incremental
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed intermediate position is both absolutely as well as incrementally programmed.
Remedy: --
61806 [Channel %1: ] Block %2: Wrong axis assignment
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The axis-assignment sequence is wrong.
Remedy: --
61807 [Channel %1: ] Block %2: Wrong spindle direction programmed (active)
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed spindle direction contradicts the spindle direction planned for the cycle.
Remedy: Check parameters SDR and SDAC.
61808 [Channel %1: ] Block %2: Final drilling depth or single drilling depth missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The total depth Z or individual drilling depth Q is missing from theG8xblock (initial cycle call).
Remedy: --
61809 [Channel %1: ] Block %2: Drill position not permissible
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: --
Remedy: --
418
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual