Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 271

Definitions: At this point, the block context calls for a machine axis. This is the case with:
- G74 (reference point approach)
- G75 (fixed point approach)
- PRESETON/PRESETONS on GANTRY synchronous axis
If a geometry or special axis identifier is used, then it must also be permitted as machine axis identifier (MD10000
$MN_AXCONF_MACHAX_NAME_TAB
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Use machine axis identifier when programming.
Program Clear alarm with the RESET key. Restart part program
Continuation:
18000 [Channel %1: ] Block %2 NCK-specific protection zone %3 wrong. Error code %4
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Number of NCK protection zone
%4 = Error specification
Definitions: There is an error in the definition of the protection zone. The error number gives the specific reason for the alarm:
No.Meaning
1: Incomplete or conflicting contour definition.
2: Contour encompasses more than one surface area.
3: Tool-related protection zone is not convex.
4: If both boundaries are active in the 3rd dimension of the protection zone and both limits have the same value.
5: The number of the protection zone does not exist (negative number, zero or greater than the maximum number of
protection zones).
6: Protection zone definition consists of more than 10 contour elements.
7: Tool-related protection zone is defined as inside protection zone.
8: Incorrect parameter used.
9: Protection zone to be activated is not defined.
10: Incorrect modal G code used for protection zone definition.
11: Contour definition incorrect or frame activated.
12: Other, not further specified errors.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department. Modify definition of the protection zone and check MD.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
18001 [Channel %1: ] Block %2 channel-specific protection zone %3 incorrect. Error code %4
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Number of the channel-specific protection zone
%4 = Error specification
Definitions: There is an error in the definition of the protection zone. The error number gives the specific reason for the alarm.
No.Meaning
1: Incomplete or conflicting contour definition.
2: Contour encompasses more than one surface area.
3: Tool-related protection zone is not convex.
4: If both boundaries are active in the 3rd dimension of the protection zone and both limits have the same value.
5: The number of the protection zone does not exist (negative number, zero or greater than the maximum number of
protection zones).
6: Protection zone definition consists of more than 10 contour elements.
7: Tool-related protection zone is defined as inside protection zone.
8: Incorrect parameter used.
9: Protection zone to be activated is not defined.
10: Incorrect modal G code used for protection zone definition.
Diagnostics Manual
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
SINUMERIK 808D ADVANCED alarms
3.2 NCK alarms
271