Drive Unit: Acquiring The Component Topology And Configuring Automatically - Siemens SINUMERIK 840DiE sl Manual

01/2007
9.2.2 Drive unit: Acquiring the component topology and configuring
automatically
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
The following example format illustrates the configuration of a drive unit:
S
Control Unit: CU 320
S
Infeed: Active Line Module (ALM)
S
Power module 1: Single Motor Module (SMM)
S
Power module 2: Double Motor Module (DMM)
S
Sensor module 1 – 3: Sensor Module Cabinet (SMC)
S
Motor 1 – 3: Standard motor without DRIVE–CliQ connection
CU 320 ALM
X103
X102
X101
X202 X202
X100
X201 X201
X200 X200
DRIVE–CLiQ connection
Note
The following actions refer to recording of the component topology online and
configuring a drive unit. If there are several drive units in a project, you must
perform the actions for each additional drive unit.
9 Drive Commissioning (SINAMICS)
9.2 ONLINE commissioning
SMC
SMM DMM
SMC
X203
X202
X201
SMC
X200
Motor_1
Motor_3
Motor_2
9-247