Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 95

Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Modify part program.
Program Clear alarm with the RESET key. Restart part program
Continuation:
8102 [Channel %1: ] Block %2 motion synchronous action: %3 function not possible
Parameters: %1 = Channel number
%2 = Block number, line number
%3 = Synact ID
Definitions: - Impossible due to embargo regulations:
- 1. Synchronous actions: Writing of feed, override and axial offsets ($AA_VC, $AC_VC, $AA_OVR, $AA_VC and
$AA_OFF) from synchronous actions as well as Continuous Dressing can be programmed only once in a block.
- 2. Extended measurement: 'Cyclic measurement' (MEAC) and 'Measurement from synchronous action' is not
possible.
- 3. Axis interpolation: The number of axes interpolating with one another must not exceed 4 (this also includes
synchronous coupling of axes via synchronous actions "DO POS[X]=$A..." "DO FA[X]=$A...").
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Modify part program.
Program Clear alarm with the RESET key. Restart part program
Continuation:
9000 Handwheel %1 failed
Parameters: %1 = Handwheel number
Definitions: For PROFIBUS/PROFINET only:
PROFIBUS handwheel has failed
Reaction: Interface signals are set.
Alarm display.
Remedy: Restore connection to PROFIBUS handwheel
Program Alarm display showing cause of alarm disappears. No further operator action necessary.
Continuation:
10203 [Channel %1: ] NC start without reference point (action=%2<ALNX>)
Parameters: %1 = Channel number
%2 = Action number/action name
Definitions: NC start has been activated in the MDI or AUTOMATIC mode and at least one axis that needs to be referenced has
not reached its reference point.
Reaction: Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department. Via the channel-specific MD20700:
$MC_REFP_NC_START_LOCK (NC Start without reference point) you can decide whether or not the axis has to be
referenced before NC Start. The start of referencing can be enabled channel-specific or axis-specific.
Channel-specific reference point approach: The rising edge of the NC/PLC interface signal DB3200 DBX1.0 (Activate
referencing) starts an automatic sequence which starts the axes of the channel in the same sequence as specified in
the axis-specific MD34110 $MA_REFP_CYCLE_NR (axis sequence channel-specific referencing). 0: The axis does
not participate in channel-specific referencing, but it must be referenced for NC Start, -1: The axis does not participate
in channel-specific referencing, but it need not be referenced for NC Start, 1- 8: Starting sequence for the channel-
specific referencing (simultaneous start at the same no.), 1 - 31: CPU type
Axis-specific referencing: Press the direction key that corresponds to the approach direction in the axis-specific
MD34010 $MA_REFP_CAM_MDIR_IS_MINUS (reference point approach in minus direction).
Diagnostics Manual
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
SINUMERIK 808D ADVANCED alarms
3.2 NCK alarms
95