Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 352

SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
61041 [Channel %1: ] Block %2: Line range too large: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy:
61042 [Channel %1: ] Block %2: Program name %4 illegal
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: In the case of multi-channel systems, the main program name must not end with _Cxx (xx stands for figures).
Rename main program.
61043 [Channel %1: ] Block %2: Error affecting coordinate conversion (%4)
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: 1: Type not specified
2: Error during tool identification
3: Meas. point 1 not available
4: Meas. point 2 not available
5: Meas. point 3 not available
4: Meas. point 4 not available
7: No reference point available
8: No direction of approach
9: Meas. points are identical
10: Alpha is incorrect
11: Phi is incorrect
12: Incorrect direction of approach
13: Lines do not intersect
14: Planes not available
15: No frame or incorrect frame selected
16: Not enough memory available
17: Internal error
61044 %[[Channel %1: ] Block %2: %]Illegal character(s) in file name: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: Remove illegal character from file name
Permitted characters are: letters, figures, underscore, slash with path name
61045 [Channel %1: ] Block %2: Job list not found: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: The specified job list could not be found.
Check name and contents of job list.
The job list must be in the same workpiece as the part program.
61046 [Channel %1: ] Block %2: Part program not found in job list: %4
Parameters: %1 = Channel number
%2 = Block number, label
352
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual