Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 11
Hide thumbs
Also See for SINUMERIK 808D ADVANCED:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages)
Table of Contents
Advertisement
Selecting a PLC restart mode
Proceed through the following steps to select a PLC restart mode:
Selecting a drive restart mode
Proceed through the following steps to select an drive restart mode:
Diagnostics Manual
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
1.
Select the desired operating area.
+
2.
Press this softkey.
3.
Press this softkey to open the window for selecting the PLC start-up
mode.
4.
Select a desired mode with the cursor keys. Two PLC start-up
modes are available:
5.
Use this key to select/deselect the PLC debugging.
6.
Press this softkey to confirm your selection. The system then restarts
in the mode selected.
1.
Select the desired operating area.
+
2.
Press this softkey.
3.
Press this softkey to open the window for selecting the drive start-up
mode.
4.
Select a desired mode with the cursor keys. Two drive start-up
modes are available:
5.
Press this softkey to confirm your selection, and then the drive list
window opens displaying all the connected drives.
Operating in the "SYSTEM" area
2.2 Setting start-up function
11
Hide quick links:
Advertisement
Table of Contents
