Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 384

SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
61309 [Channel %1: ] Block %2: Check probe type
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: Measurement of workpiece:
Check tool type of measuring probe in TOOLMAN.
When measuring workpiece milling, it is preferred to use tool types 710, 712, 713 or 714. But a type 1xy can also be
used.
Type 710 is permitted for workpiece measurement in all measuring cycles. Types 712, 713 and 714 are intended for
special measuring tasks.
When measuring workpiece turning, it is preferred to use tool type 580. However, a type 1xy can also be used, but
only if setting data $SC_TOOL_LENGTH_TYPE=2 is set.
Measurement of tool:
For measuring tool milling, no permissible tool probe type is entered in SD54633 $SNS_MEA_TP_TYPE[S_PRNUM-
1] or SD54648 $SNS_MEA_TPW_TYPE[S_PRNUM-1] and/or
check the permissible working plane G17...G19 for tool type "Disk".
61310 [Channel %1: ] Block %2: Scale factor is active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Scale factor = scaling is active.
Remedy: Switch off the active scale factor in the program. Measuring is not possible with an active scale factor.
61311 [Channel %1: ] Block %2: No D number active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No tool offset for the measuring probe (for workpiece measurement) or no tool offset for the active tool (for tool
measurement) is selected.
Remedy: Select the tool's tool edge number D.
61312 [Channel %1: ] Block %2: Check measuring cycle number
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: Measuring cycle called is impermissible...
61313 [Channel %1: ] Block %2: Check probe number
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: Check parameter S_PRNUM
Measure workpiece: Parameter S_PRNUM 1 to 12
Measure tool: Parameter S_PRNUM 1 to 6
61314 [Channel %1: ] Block %2: Check selected tool type
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: Measure workpiece:
- Specify new S_PRNUM or recalibrate probe
- Check calibration status in the setting data
- Check whether the probe (type 7xx or 5xx) is suitable for the measuring task
384
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual