Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 57

2900 Reboot is delayed
Definitions: This alarm indicates a delayed reboot.
This alarm only occurs when reboot was carried out by the HMI and MD10088 $MN_REBOOT_DELAY_TIME was set
greater than zero.
The alarm can be suppressed with MD11410 $MN_SUPPRESS_ALARM_MASK Bit 20.
Reaction: NC not ready.
The NC switches to follow-up mode.
Mode group not ready, also effective for single axes.
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Alarm reaction delay is canceled.
Remedy: See MD10088 $MN_REBOOT_DELAY_TIME and MD11410 $MN_SUPPRESS_ALARM_MASK.
Program Switch control OFF - ON.
Continuation:
3000 Emergency stop
Definitions: The EMERGENCY STOP request is applied to the NCK/PLC interface DB2600 DBX0.1 (Emergency stop).
Reaction: NC not ready.
Mode group not ready, also effective for single axes.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Alarm reaction delay is canceled.
Remedy: Please inform the authorized personnel/service department. Remove the cause of the emergency stop and
acknowledge the emergency stop via the PLC/NCK interface DB2600 DBX0.2 (emergency stop acknowledgement).
Program Restart part program.Clear alarm with the RESET key in all channels of this mode group. Restart part program.
Continuation:
4000 [Channel %1: ] Machine data %2[%3] has gap in axis assignment
Parameters: %1 = Channel number
%2 = String: MD identifier
Definitions: The assignment of a machine axis to a channel by the MD20070 $MC_AXCONF_MACHAX_USED must be
contiguous. At system power-up (Power On) gaps are detected and displayed as an alarm.
Reaction: NC not ready.
Mode group not ready, also effective for single axes.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. The entries for the indices for the machine axes used in
the channels must be contiguous in table MD20070 $MC_AXCONF_MACHAX_USED. Channel axis gaps must be
enabled via MD11640$MN_ENABLE_CHAN_AX_GAP.
Program Switch control OFF - ON.
Continuation:
4002 [Channel %1: ] Machine data %2[%3] assigns an axis not defined in channel
Parameters: %1 = Channel number
%2 = String: MD identifier
%3 = Index: MD array index
Diagnostics Manual
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
SINUMERIK 808D ADVANCED alarms
3.2 NCK alarms
57