Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 355

61062 %[[Channel %1: ] Block %2: %]Axis position %4incorrectly programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: Check the last programmed axis position
61063 %[[Channel %1: ] Block %2: %]Tool at magazine location %4 is not a multitool
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A magazine location and a multitool location were programmed. However, there is no multitool at the magazine
location.
Remedy: Only program the magazine location (without multitool location).
61064 %[[Channel %1: ] Block %2: %]Invalid multitool location: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A multitool location was programmed, at which there is no multitool.
Remedy: Program a valid multitool location.
61065 [Channel %1: ] Block %2: A channel specified in the job list does not exist: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A non-existent channel was specified in the job list.
Remedy: Correct job list
61066 %[[Channel %1: ] Block %2: %]Cycle %4 requires G code G70 or G71
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Cycle requires G code G70 or G71
Remedy: Program G70 or G71
61098 [Channel %1: ] Block %2: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: This alarm is used for various purposes.
Please refer to the alarm text.
Remedy: Depends on alarm text
61099 [Channel %1: ] Block %2: Internal cycle error (%4)
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy:
61101 %[[Channel %1: ] Block %2: %]Reference point defined incorrectly
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: With an incremental specification of the depth, either different values have to be selected for the reference point
(reference plane) and the retraction plane, or an absolute value must be specified for the depth.
Diagnostics Manual
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
355