Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 372
Hide thumbs
Also See for SINUMERIK 808D ADVANCED:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages)
Table of Contents
Advertisement
SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
61219
[Channel %1: ] Block %2: Tool radius too large
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The tool radius is too large for machining.
Remedy:
Select a suitable tool.
61220
[Channel %1: ] Block %2: Tool radius too small
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The tool radius is too small for machining.
Remedy:
Select a suitable tool.
61221
[Channel %1: ] Block %2: No tool active
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
No tool active.
Remedy:
Select a suitable tool.
61222
[Channel %1: ] Block %2: Plane infeed greater than tool diameter
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The plane infeed must not be greater than the tool diameter.
Remedy:
Reduce plane infeed.
61223
[Channel %1: ] Block %2: Approach path too small
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The approach path must not be less than zero.
Remedy:
Enter a greater value for the approach path.
61224
[Channel %1: ] Block %2: Retract path too small
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The retract path must not be less than zero.
Remedy:
Enter a greater value for the retract path.
61225
[Channel %1: ] Block %2: Swivel data record unknown
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
An attempt was made to access a swivel data block which has not been defined.
Remedy:
Select another swivel data block or define a new swivel data block.
61226
[Channel %1: ] Block %2: Swivel head cannot be exchanged
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The parameter "Swivel data block" is set to "No". In spite of this, an attempt has been made to change the swivel head.
Remedy:
Set the parameter "Swivel data block" in the setup screen "Rotary axes" to "Automatic" or "Manual".
372
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual
Hide quick links:
Advertisement
Table of Contents
