Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 354

SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
61054 [Channel %1: ] Block %2: Programs started from various job lists: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Programs from various job lists were started simultaneously.
This is illegal. All programs must be assigned to the same job list.
Remedy: Select desired job list again, and start programs afresh.
61055 [channel %1: ] block %2: magazine location number too low: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The magazine location number entered was too low.
Remedy:
61056 [channel %1: ] block %2: magazine location number too high: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The magazine location number entered was too high.
Remedy:
61057 [Channel %1: ] Block %2: magazine location number is no integer: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The magazine location number must be an integer.
Remedy:
61058 %[[channel %1: ] block %2: %]Function %4 not released
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: - CYCLE952: balance cutting function must be released via MD52218 $MCS_FUNCTION_MASK_TURN, bit6.
61059 %[[Channel %1: ] Block %2: %]Tool preselection failed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: --
Remedy: --
61060 %[[Channel %1: ] Block %2: %]Function requires tool management
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: --
Remedy: --
61061 %[[Channel %1: ] Block %2: %]Different scaling in the plane and depth
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: --
354
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual