Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 262

SINUMERIK 808D ADVANCED alarms
3.2 NCK alarms
Definitions: In the displayed block, a tool holder that is not defined is accessed.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Check the programming of the tool holder in the NC program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
17200 [Channel %1: ] Block %2: Data of tool %3 cannot be deleted.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = T number
Definitions: An attempt has been made to delete from the part program the tool data for a tool currently being processed. Tool data
for tools involved in the current machining operation may not be deleted. This applies both for the tool preselected with
T or that has been changed in place of another, and also for tools for which the constant grinding wheel peripheral
speed or tool monitoring is active.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Check access to tool offset memory by means of $TC_DP1[t,d] = 0 or deselect tool.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
17210 [Channel %1: ] Block %2 access to variable not possible
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The variable cannot be written/read directly from the part program. It is allowed only in motion synchronous actions.
Example for variable:
$P_ACTID (which planes are active)
$AA_DTEPB (axial distance-to-go for reciprocating infeed)
$A_IN (test input)
Safety Integrated: Safety PLC system variables can only be read during the safety SPL setup phase.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
17224 [Channel %1: ] Block %2 tool T/D= %3 - tool type %4 is not permitted
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Incorrect T no. / D no.
%4 = Incorrect tool type
Definitions: On this system, it is not possible to select tool offsets of the
indicated tool types.
The variety of tool types can both be limited by the machine OEM
and be reduced on individual control models.
Only use tools of the tool types permitted for this system.
Check whether an error has occurred on defining the tool.
Reaction: Correction block is reorganized.
Interpreter stop
Interface signals are set.
Alarm display.
Remedy: Correct the NC program or correct the tool data
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
262
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual