Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 379

61272 %[[Channel %1: ] Block %2: %]Insertion depth too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Insertion depth on chamfering too small.
Remedy: Increase the insertion depth.
61273 %[[Channel %1: ] Block %2: %]Insertion depth too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Insertion depth on chamfering too large.
Remedy: Decrease the insertion depth.
61274 %[[Channel %1: ] Block %2: %]Invalid tool angle
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Invalid tool angle.
Remedy: Check tool angle
61275 [Channel %1: ] Block %2: Target point violates software limit switch!
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Due to a swivel action, the end point is outside the software limit switches.
Remedy: Select another retraction plane or approach a suitable interpolation point.
61276 [Channel %1: ] Block %2: External tool diameter required for restrictions
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Outer tool diameter required in case of delimitations.
Remedy: Specify the outer tool diameter.
61277 [Channel %1: ] Block %2: Tool diameter larger than restriction
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Tool diameter larger than delimitation.
Remedy: Use a smaller tool.
61278 [Channel %1: ] Block %2: If tool angle is larger than 90°, both tool diameters must be
equal
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: For tool angles larger than 90°, the two tool diameters must be identical.
Remedy: Correct the tool angle or the tool diameters.
61279 [Channel %1: ] Block %2: If tool angle equals 90°, both tool diameters must be equal
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: For tool angles equal to 90°, the two tool diameters must be identical.
Remedy: Correct the tool angle or the tool diameters.
Diagnostics Manual
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
379