Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 362

SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
61147 [Channel %1: ] Block %2: Transformation not active: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: The stated transformation is not active.
You have to activate the transformation before you can use it.
61148 [Channel %1: ] Block %2: Swivel plane with active turning tool not possible
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Swiveling the plane is not possible when a turning tool is active.
Remedy: Load a milling tool before you swivel the plane.
The alarm can be suppressed using SD 55410 $SCS_MILL_SWIVEL_ALARM_MASK.
61149 [Channel %1: ] Block %2: Positioning a milling tool with active turning tool is not
possible
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Milling tools cannot be positioned if a turning tool is active.
Remedy: Load a milling tool, before you call positioning.
61150 [Channel %1: ] Block %2: Tool cannot be aligned - error code: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: Causes of error:
1st error code = A -> only new swivel plane permitted, see parameter _ST
61151 [Channel %1: ] Block %2: Orientation of tool not possible - error code: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: Causes of error:
1st error code = A -> only additive swivel plane permitted, see parameter _ST
61152 [Channel %1: ] Block %2: B axis kinematics (turning technology) either not or
incorrectly set up in Start-up of swivel cycle - error code: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: Causes of error:
1st error code = A123 -> B axis not an automatic rotary axis under ShopTurn (123 corresponds to parameter _TCBA)
2nd error code = B123 -> B axis not activated in swiveling start-up (kinematics)
61153 [Channel %1: ] Block %2: No 'Rotary axes direct' swivel mode possible - error code:
%4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
362
(123 corresponds to $TC_CARR37[n], n ... number of the swivel data record)
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual