Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 210

SINUMERIK 808D ADVANCED alarms
3.2 NCK alarms
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14840 [Channel %1: ] Block %2 incorrect value range for constant cutting speed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed cutting speed is not within the input range
Input range metric: 0.01 to 9 999.99 [m/min]
Input range inch: 0.1 to 99 999.99 [inch/min]
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Program cutting speed under address S within the permissible range of values.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14850 [Channel %1: ] Block %2 changing the reference axis for a constant cutting speed not
allowed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The attempt was made via the SCC[AX] instruction to change the reference
axis for a constant cutting speed.
This is not allowed if the indicated axis is no geometry axis.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
Remedy: Please inform authorized personnel/service.
When programming SCC[AX] indicate a geometry axis known in the channel.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14860 [Channel %1: ] Block %2 Selection of the tool cutting rate not allowed. Cause %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Cause of the error
Definitions: Selection of the cutting rate SVC is not permissible in the current state
Causes of the problem: the following function is active.
1: Constant cutting rate G96, G961 or G962 active
2: SPOS/SPOSA/M19 (spindle positioning mode) active
3: M70/axis mode active
4: SUG active
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
Remedy: Activate the speed control mode for the spindle prior to programming SVC, for example with M3, M4 or M5.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14861 [Channel %1: ] Block %2 SVC programmed, but no tool offset active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Cutting velocity SVC programmed in the block, but no tool offset active.
Reaction: Correction block is reorganized.
Local alarm reaction.
210
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual