Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 422

SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
61864 [Channel %1: ] Block %2: The selection, tailstock yes/no must be identical in all
channels
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The selection, tailstock yes/no in the program header must be identical in all channels.
Remedy: For tailstock yes/no in the program header, make the same selection for all channels.
61865 [Channel %1: ] Block %2: Calling a ShopTurn cycle is only permissible in a ShopTurn
program
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: It is not permissible that a ShopTurn cycle is used outside a ShopTurn program, as the required environment variables
are otherwise not assigned.
Remedy: Calling a ShopTurn cycle in a ShopTurn program. If this is not possible, then the task must be programmed using G
code.
61866 [Channel %1: ] Block %2: It is only permissible to call a ShopMill cycle in a ShopMill
program
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: It is not permissible that a ShopMill cycle is used outside a ShopMill program, as the required environment variables
are otherwise not assigned.
Remedy: Calling a ShopMill cycle in a ShopMill program. If this is not possible, then the task must be programmed using G code.
61867 [Channel %1: ] Block %2: On face C, the retraction distance must not be larger than the
distance to the center point.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Retraction distance too large. On face C, the retraction distance must not be larger than the distance to the center
point.
Otherwise, retraction would become negative, which would lead to a reversal of the work spindle.
Remedy: Use a smaller retraction distance or face Y if possible.
61868 [Channel %1: ] Block %2: Program was created on another machine and must be
adjusted.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The program was created on another machine and contains program parts that can not be executed on this machine.
Remedy: The program must be adjusted in the ShopMill/ShopTurn editor.
61900 %[[Channel %1: ] Block %2: %]Name of program to be generated is missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: - Check parameter PRG
61901 %[[Channel %1: ] Block %2: %]Contour %4 does not exist
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
422
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual