Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 86

SINUMERIK 808D ADVANCED alarms
3.2 NCK alarms
6437 [Channel %1: ] Block %2 Command '%3' cannot be programmed. Function '%4' is
activated.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Programmed command
%4 = Function identifier
Definitions: The command cannot be programmed as the specified function is active.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Correct the NC program
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
6452 [Channel %1: ] Block %2 tool change not possible. Tool holder/spindle number = %3
not defined.
Parameters: %1 = Channel ID
%2 = Block number, label
%3 = Tool holder/spindle number
Definitions: The desired tool change is not possible. The toolholder/spindle number has not been defined.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: General: The following must apply: 'maximum programmed address extension s (=spindle number/toolholder number)
of Ts=t, Ms=6 must be less than the value of MD18076 $MN_MM_NUM_LOCS_WITH_DISTANCE.
With magazine management: Check whether the toolholder number/spindle number and the magazine data have
been defined correctly.
(See also the system variables $TC_MPP1, $TC_MPP5 of the buffer magazine).
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
6500 NC memory full
Definitions: The NCK file system is full.
The available buffered memory does not suffice. Note: At first commissioning, files of the NC file system may be
affected such as drive data, MMC files, FIFO files, NC programs...
Reaction: Alarm display.
Remedy: Adjust the size of the buffered memory (MD18230 $MN_MM_USER_MEM_BUFFERED) or increase the space
available in the buffered memory, e.g. by unloading part programs that are no longer being used. Or decrease the size
of the ring buffer (see $MC_RESU_RING_BUFFER_SIZE).
Program Clear alarm with the Delete key or NC START.
Continuation:
6510 Too many part programs in the NC memory
Definitions: The maximum number of possible files in the NC file system (part of the NC memory) has been reached. Note: During
first commissioning, this can affect files from the NC file system, e.g. drive data, MMC files, FIFO files, NC programs, ...
Reaction: Alarm display.
Remedy: Please inform the authorized personnel/service department.
- Delete or unload files (e.g. part programs), or
- Increase MD18320 $MN_MM_NUM_FILES_IN_FILESYSTEM or MD18321
MD_MAXNUM_SYSTEM_FILES_IN_FILESYSTEM.
Program Clear alarm with the Delete key or NC START.
Continuation:
86
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual