Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 375

61241 [Channel %1: ] Block %2: Retraction plane not defined for this machining direction
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No retraction plane has been defined for the selected machining direction.
Remedy: Define the missing retraction plane.
61242 [Channel %1: ] Block %2: Wrong machine direction
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The machining direction has been specified incorrectly.
Remedy: Check the programmed machining direction.
61243 [Channel %1: ] Block %2: Correct tool change point, tool tip in retraction area!
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The tool change point must be situated so far outside the retraction area that no tool protrudes into the retraction area
on turret swivelling.
Remedy: Specify another tool change point.
61244 [Channel %1: ] Block %2: Pitch change leads to undefined thread
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The specified pitch change causes a reversal of the thread direction.
Remedy: Check thread pitch change and thread geometry.
61245 [Channel %1: ] Block %2: Machining plane does not match modal machining plane
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Machining plane does not match modal one.
Remedy: Check the machining plane.
61246 [Channel %1: ] Block %2: Safety distance too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The safety clearance is too small for machining.
Remedy: Increase safety clearance.
61247 [Channel %1: ] Block %2: Blank radius too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The blank radius is too small for machining.
Remedy: Increase blank radius.
61248 [Channel %1: ] Block %2: Infeed too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The infeed is too small for machining.
Remedy: Increase infeed.
Diagnostics Manual
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
375