Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 310

SINUMERIK 808D ADVANCED alarms
3.2 NCK alarms
22321 [Channel %1: ] Axis %2 PRESET not allowed during traverse motion
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A preset command was sent from the HMI or PLC while an axis was traveling in JOG mode.
Reaction: Interface signals are set.
Alarm display.
Remedy: Wait until the axis is stationary.
Program Clear alarm with the Delete key or NC START.
Continuation:
22322 [Channel %1: ] Axis %2 PRESET: illegal value
Parameters: %1 = Channel number
%2 = Axis name, spindle number
Definitions: The entered Preset value is too large (number format overflow).
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Use more realistic (smaller) Preset values.
Program Clear alarm with the RESET key. Restart part program
Continuation:
22324 [Channel %1: ] Block %2 Axis %3 PRESETON or PRESETONS not permitted (cause:
%4)
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Index describing the problem that occured in more detail
Definitions: A problem has occurred when programming PRESETON or PRESETONS. This problem is described in more detail
using the "Index" parameter:
Index == 1: In MD30460 $MA_BASE_FUNCTION_MASK the PRESETON or PRESETONS function is deactivated.
Index == 2: For PRESETONS, the axis is monitored for collision. Actual value setting is not permitted.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Apply the programming permitted.
Please notify the authorized personnel/service.
Program Clear alarm with the RESET key. Restart part program
Continuation:
22400 [Channel %1: ] Option 'contour handwheel' not set
Parameters: %1 = Channel number
Definitions: The function 'contour handwheel' was activated without the neccesary option.
If the alarm occurs
- on selection of the contour handwheel via the PLC, then the contour handwheel has to be deselected in order to
continue with the program
- on account of programming FD=0, then the program can be corrected and continued with the compensation block
and NCSTART.
Reaction: Alarm display.
Remedy: Please inform the authorized personnel/service department.
- Set option
- Cancel the activation of the function 'contour handwheel'
- Modify part program.
310
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual