Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 415

Remedy: - Check cutting edge position in tool management
61739 %[[Channel %1: ] Block %2: %]Blank must be closed contour
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: - Check whether the blank contour is closed
61740 %[[Channel %1: ] Block %2: %]Collision through approach
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: - Select the starting position to enable collision-free approach of the contour
61741 %[[Channel %1: ] Block %2: %]Axis in negative range
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: - Check the position of the axis in the ordinate
61742 %[[Channel %1: ] Block %2: %]Retraction plane %4 is within the machining range
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: - On internal machining check machining range in relation to the entered
retraction distance ($SCS_TURN_ROUGH_I_RELEASE_DIST)
61743 %[[channel %1: ] block %2: %]Guide channel for two-channel cutting missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: - Check if a guide channel has been defined
61744 %[[channel %1: ] block %2: %]Following channel for two-channel cutting missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: - Check if a following channel has been defined
61745 %[[channel %1: ] block %2: %]Two-channel cutting in two guide channels (%4) active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: - Check if two guide channels are active
- Check if two-channel cutting is active simultaneously in more than two channels
- Two channels only may be active: a guide and a following channel
61746 %[[channel %1: ] block %2: %]Two-channel cutting active already in the channels (%4)
Parameters: %1 = Channel number
%2 = Block number, label
Diagnostics Manual
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
415