Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 426

SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
Remedy: - Modify contour programming
61935 %[[Channel %1: ] Block %2: %]Programming of inch/metric measuring system not
allowed here
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: - Modify contour programming
61936 %[[Channel %1: ] Block %2: %]G0 is not allowed in contour programming
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: - Modify contour programming, replace G0 by G1
61937 %[[Channel %1: ] Block %2: %]Pocket depth programmed incorrectly
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: - Check parameter Z1
61938 %[[Channel %1: ] Block %2: %]No starting point specified
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: - Check parameter for specified starting point,
- for G17: XS, YS
- for G18: ZS, XS
- for G19: YS, ZS
61939 %[[Channel %1: ] Block %2: %]No center point specified for circle
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: - Check contour programming, particularly circular-path programming
61940 %[[Channel %1: ] Block %2: %]Specified starting point programmed incorrectly
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: - Correct specified starting point
61941 %[[Channel %1: ] Block %2: %]Helix radius too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: - Increase helix radius
426
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual