Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 408
Hide thumbs
Also See for SINUMERIK 808D ADVANCED:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages)
Table of Contents
Advertisement
SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
61564
%[[Channel %1: ] Block %2: %]Feed insertion is smaller than or equal to zero
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy:
Check values in grinding wheel data
61565
[Channel %1: ] Block %2: Feed dressing is smaller than or equal to zero
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy:
Check values in grinding wheel data
61566
[Channel %1: ] Block %2: Chamfer / radius are larger than the grinding wheel width
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy:
Check values in grinding wheel data
61567
[Channel %1: ] Block %2: %4 Total infeed depth and sum of the infeed must have the
same sign
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy:
Check the signs of the infeeds
61601
[Channel %1: ] Block %2: Finished part diameter too small
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Remedy:
Check parameter SPD or DIATH.
61602
[Channel %1: ] Block %2: Tool width incorrectly defined
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Plunge cutter is larger than the programmed groove width.
Remedy:
Check tool or change program.
61603
[Channel %1: ] Block %2: Recess type incorrectly defined
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Radii/chamfers at the groove base do not match the groove width. Face groove on a contour element running parallel
to the longitudinal axis is not possible.
Remedy:
Check parameter VARI.
61604
[Channel %1: ] Block %2: Active tool violates programmed contour
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Contour violation in the relief cut elements due to the tool clearance angle of the tool used.
Remedy:
Use a different tool or check the contour subroutine.
408
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual
Hide quick links:
Advertisement
Table of Contents
