Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 348

SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
61010 [Channel %1: ] Block %2: Finishing allowance too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The finishing allowance for the base is greater than the total depth.
Remedy: Reduce finishing allowance.
61011 [Channel %1: ] Block %2: Scaling not permissible
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A scale factor is active which is illegal for this cycle.
Remedy: Modify scale factor.
61012 %[[Channel %1: ] Block %2: %]Different scaling in planes
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Remedy: --
61013 [Channel %1: ] Block %2: Basic settings were changed, program cannot be executed
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The basic settings are not compatible with the generated program.
Remedy: Check and, if necessary, change the basic settings.
61014 [Channel %1: ] Block %2: Return plane exceeded
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy: Check parameter RTP.
61015 [Channel %1: ] Block %2: Contour is not defined
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy:
61016 [Channel %1: ] Block %2: System frame for cycles missing
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy: Set MD 28082: MM_SYSTEM_FRAME_MASK, Bit 5=1.
61017 %[[Channel %1: ] Block %2: %]Function %4 not present in NCK
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy:
348
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual