Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 307

Program Clear alarm with the Delete key or NC START.
Continuation:
22272 [channel %1: ] block %2 axis %3 thread cutting: block length %4 too short for
predefined thread pitch
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name
%4 = Block length
Definitions: Thread cutting with G33, G34, G35: Block length too short for predefined thread pitch. Block length is displayed.
Reaction: Alarm display.
Remedy: Reduce thread pitch (thread pitch change).
Program Clear alarm with the Delete key or NC START.
Continuation:
22275 [Channel %1: ] Block %2 zero velocity of thread axis at position %3 reached
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Position
Definitions: An axis standstill was reached at the specified position during thread cutting with G35 due to the linear decrease in
the thread pitch. The standstill position of the thread axis depends on:
- Programmed thread pitch decrease
- Thread length
Reaction: Alarm display.
Remedy: Change at least one of the above factors.
Program Clear alarm with the Delete key or NC START.
Continuation:
22280 [Channel %1: ] In block %2: Prog. acceleration path too short %3, %4 required
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Prog. acceleration path
%4 = Required acceleration path
Definitions: In order to stay within the programmed acceleration path, the acceleration caused an overload on the thread axis. In
order to accelerate the axis with the programmed dynamic response, the length of the acceleration path must be at
least as large as the value in parameter %4.
The alarm is of the technological type and is output whenever bit 2 in MD11411 $MN_ENABLE_ALARM_MASK is
enabled. The HMI softkey 'Technology support' sets and clears this bit in the MD.
Reaction: Alarm display.
Remedy: Modify part program or reset MD11411 $MN_ENABLE_ALARM_MASK bit 2.
Program Clear alarm with the Delete key or NC START.
Continuation:
22290 [Channel %1: ] Spindle operation for transformed spindle/axis %2 not possible
(reason: error code %3).
Parameters: %1 = Channel number
%2 = Axis name, spindle number
%3 = Error code
Definitions: It is impermissible to start a spindle as long as it is being used by a transformation. Reason: spindle usage in a
transformation requires axis operation, which must not be exited.
This alarm may have the following reasons:
- Error code 1 : M3, M4 or M5 per synchronized action;
- Error code 2 : M41 through M45 per synchronized action;
- Error code 3 : SPOS, M19 per synchronized action;
- Error code 11 : DB380x DBX5006.0 (Spindle stop);
- Error code 12 : DB380x DBX5006.1 (Spindle start clockwise rotation);
Diagnostics Manual
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
SINUMERIK 808D ADVANCED alarms
3.2 NCK alarms
307