Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 220

SINUMERIK 808D ADVANCED alarms
3.2 NCK alarms
Program Clear alarm with the Delete key or NC START.
Continuation:
15340 [Channel %1: ] Block %2 invalid label as search target
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Syntax error! A label must have at least 2 but no more than 32 characters, and the first two characters must be
alphabetic or underscore characters. Labels must be concluded with a colon.
Reaction: Alarm display.
Remedy: Repeat the input with corrected label.
Program Clear alarm with the Delete key or NC START.
Continuation:
15350 [Channel %1: ] Block %2 search target not found
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The specified program has been searched to the end of the program without the selected search target having been
found.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check the part program, change the block search (typing error in the part program) and restart the search.
Program Clear alarm with the RESET key. Restart part program
Continuation:
15360 [Channel %1: ] Illegal target of block search (syntax error)
Parameters: %1 = Channel number
Definitions: The specified search target (block number, label or string) is not allowed in block search.
Reaction: Alarm display.
Remedy: Correct target of block search.
Program Clear alarm with the Delete key or NC START.
Continuation:
15370 [Channel %1: ] Target of block search not found
Parameters: %1 = Channel number
Definitions: In a block search, an impermissible search target has been specified (e.g. negative block number).
Reaction: Alarm display.
Remedy: Check the specified block number, label or character string. Repeat entry with correct search target.
Program Clear alarm with the Delete key or NC START.
Continuation:
15380 [Channel %1: ] Block %2 illegal incremental programming in axis %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis
Definitions: The first axis programming after "search to block end point" is performed incrementally. This is not allowed in the
following situations:
- After searching the target a transformation change has taken place.
- A frame with rotation component is active. The programmed axis is involved in the rotation.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
220
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual