Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 164

SINUMERIK 808D ADVANCED alarms
3.2 NCK alarms
12700 [Channel %1: ] Block %2 contour definition programming not allowed as modal sub-
programis active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In the external language mode, a block is programmed with contour definition and a modal cycle is active at the same
time. Because of unclear address assignment (e.g. R = radius for contour definition or return plane for drilling cycle)
contour definition programming must not be used when a modal cycle is active.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
12701 [Channel %1: ] Block %2 illegal interpolation type for contour definition active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In one contour definition block, G01 is not active as interpolation function. In one contour definition block, the linear
interpolation always has to be selected with G01. G00, G02, G03, G33 etc. are not permitted.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program. Program linear interpolation G01.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
12710 [Channel %1: ] Block %2 illegal language element in external language mode
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed language element is not allowed or unknown in external language mode. Only the language
elements from Siemens mode which are used for subprogram calls (except for Lxx) and the language constructs for
program repetition with REPEAT (UNTIL) are allowed.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Check that the language command is available in Siemens mode. Switch to Siemens mode with G290. Program the
command in the next block and switch back to the external language mode in the following block.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
12720 [Channel %1: ] Block %2 program number for macro call (G65/G66) missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: During macro call with G65/G66 no program number was defined. The program number must be programmed with
address "P".
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
164
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual