Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 378
Hide thumbs
Also See for SINUMERIK 808D ADVANCED:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages)
Table of Contents
Advertisement
SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
61264
[Channel %1: ] Block %2: Chained ShopTurn program blocks not permissible in
subprogram on pos. pattern
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
If a subroutine is called from a position pattern, the subroutine itself must not include a position pattern.
Remedy:
Reprogram machining.
61265
[Channel %1: ] Block %2: Too many restrictions, use rectangular pocket
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
In face milling a maximum of only 3 sides can be delimited.
Remedy:
Use pocket cycle.
61266
[Channel %1: ] Block %2: Illegal machining direction
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
In face milling, the delimitations and the direction of machining do not match.
Remedy:
Select another direction of machining.
61267
[Channel %1: ] Block %2: Plane infeed too large, residual corners remain
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
In face milling, the plane infeed must not exceed 85%.
Remedy:
Select a smaller plane infeed, as otherwise residual corners will be left over.
61268
[Channel %1: ] Block %2: Illegal machining direction, residual corners are left over.
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
In face milling, the machining direction does not match the selected delimitations.
Remedy:
The machining direction must be selected to match the delimitations.
61269
[Channel %1: ] Block %2: External tool diameter too small
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Incorrect tool definition.
Remedy:
Check angle and diameter of the tool used.
61270
%[[Channel %1: ] Block %2: %]Chamfer width too small
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Chamfer width selected too small.
Remedy:
Increase the chamfer width.
61271
%[[Channel %1: ] Block %2: %]Chamfer width greater than tool radius
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Chamfer width larger than tool radius.
Remedy:
Use a larger tool.
378
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual
Hide quick links:
Advertisement
Table of Contents
