Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 390

SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
Remedy: For 840D sl - up to SW 2.6 SP1 and for 828D - up to SW 4.3:
: - Parameter _SETV[0] or _SETV[1] is empty or less than 0.
For 840D sl - as from SW 2.7 and for 828D - as from SW 4.4:
: - Parameter X1 or X2 is empty or less than 0.
61347 [Channel %1: ] Block %2: Angle 1st edge - 2nd edge equals 0
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy: For 840D sl - up to SW 2.6 SP1 and for 828D - up to SW 4.3:
- Parameter following angle (_INCA) is 0.
For 840D sl - as from SW 2.7 and for 828D - as from SW 4.4:
- Parameter following angle (alpha 1) is 0.
61348 [Channel %1: ] Block %2: Angle rel. to reference edge equals 0
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy:
61349 [Channel %1: ] Block %2: Distance upper probe edge - measuring position = 0 for tool
radius measurement
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy: The distance between the upper and lower edges of the tool probe equals 0; relevant for radius measurement.
For 840D sl - up to SW 1.x: Check parameter _TP[x,9]
For 840D sl/828D - as from SW 2.5: Check setting data 54634 $SNS_MEA_TP_CAL_MEASURE_DEPTH
61350 [Channel %1: ] Block %2: Feed, speed not programmed for tool measurement with
rotating spindle
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy: For 840D sl - up to SW 2.6 SP1 and for 828D - up to SW 4.3:
- Measuring feed and/or spindle speed during tool measurement with turning spindle not entered in GUD variable
_MFS.
- Check parameter _MFS[0]
For 840D sl - as from SW 2.7 and for 828D - as from SW 4.4:
- Check parameters F1 and S1
61351 [Channel %1: ] Block %2: Tool length or radius is 0
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Remedy: Cutter: - Check length and radius of the active tool in the compensation data memory
Drill: - Check length of the active tool in the compensation data memory
- Radius or tip angle of the active tool must be predefined in the compensation data memory
61352 [Channel %1: ] Block %2: Path for logfile not permitted
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The specified path for the log file is incorrect.
390
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual