Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 387
Hide thumbs
Also See for SINUMERIK 808D ADVANCED:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages)
Table of Contents
Advertisement
- Check the actual pre-position of the workpiece probe with reference to the entered inner or outer measurement.
61327
[Channel %1: ] Block %2: Program reset required
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
NC reset required.
Remedy:
Execute NC reset.
61328
[Channel %1: ] Block %2: Check D number
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
D number in parameter _KNUM is 0.
Remedy:
For 840D sl - up to SW 2.6 SP1 and for 828D - up to SW 4.3:
- Check parameter for tool offset target (_KNUM)
For 840D sl - as from SW 2.7 and for 828D - as from SW 4.4:
- Check parameter for tool offset target (S_KNUM1)
61329
[Channel %1: ] Block %2: Check rotary axis
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Remedy:
No name assigned to the axis number specified in the parameter of the rotary axis, or this axis is not configured as a
rotary axis.
For 840D sl - up to SW 2.6 SP1 and for 828D - up to SW 4.3:
- Check MD 20080 and/or MD 30300.
For 840D sl - as from SW 2.7 and for 828D - as from SW 4.4:
- Check MD 20080, MD 30300 and/or MCS 52207 - bit6.
61330
[Channel %1: ] Block %2: Coordinate rotation active
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
No measuring possible in the rotated coordinate system.
Remedy:
Check the conditions for measuring.
61331
[Channel %1: ] Block %2: Angle too large, change measuring axis
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Remedy:
For 840D sl - up to SW 2.6 SP1 and for 828D - up to SW 4.3:
- Parameter starting angle (_STA) is too large for the measuring axis specified.
For 840D sl - as from SW 2.7 and for 828D - as from SW 4.4:
- Parameter starting angle (alpha 0) is too large for the measuring axis specified.
Select another measuring axis.
61332
[Channel %1: ] Block %2: Modify tool tip position
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The tool tip is below the measuring probe surface (e.g. for a ring gauge or cube).
Remedy:
Place the tool above the measuring probe surface.
61333
[Channel %1: ] Block %2: Check calibration block number
Parameters:
%1 = Channel number
%2 = Block number, label
Diagnostics Manual
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
SINUMERIK 808D ADVANCED alarms
3.5 Cycle alarms
387
Hide quick links:
Advertisement
Table of Contents
